Allied Telesis GS950 PS Series, Installation Manual, Page: 52 / 108

Chapter 4: Installing the Switch in an Equipment Rack
52
Beginning the Installation
This chapter contains the procedure for installing the switch in a standard
19-inch equipment rack, with the brackets included with the unit.
Required Items
The following items are required to install the switch in an equipment rack:
 Two equipment rack brackets (included with the switch)
 Eight M4x6mm bracket screws (included with the switch)
 Cross-head screwdriver (not provided)
 Four standard equipment rack screws (not provided)
Switch
Orientations in
the Equipment
Rack
You can install the switch with its front panel flush with or extending in
front of the equipment rack. The illustrations in Figure 21 on page 52 show
the two switch orientations in the equipment rack.
Figure 21. Switch Orientations in an Equipment Rack