Allied Telesis DNC10 Series, Installation And User Manual

Page: 72 / 118

Chapter 4: Modifying Advanced Properties
72
Large Send Offload v2 (IPv4)
Normally, the TCP segmentation is done by the protocol stack. When you
enable the Large Send Offload property, the TCP segmentation can be
done by the network adapter. The default setting for this property is
Enabled.
To enable or disable the Large Send Offload v2 (IPv4) feature, do the
following:
1. Access the Advanced Properties.
See “Accessing Advanced Properties” on page 58.
2. Select Large Send Offload v2 (IPv4) in the Property box.
The Large Send Offload v2 (IPv4) page is displayed as shown in
Figure 32.
Figure 32. Large Send Offload v2 (IPv4) Page
Select one of the following options:

Disabled — The feature is disabled.

Enabled — The adapter port segments large packets
up to 256Kb for IPv4 traffic before sending them out.
This is the default setting.
3. Click OK .