Chassis Installation
10
The following procedures are also available beginning on page 18:
❑
Re-installing faceplates/air-dams, if your chassis has empty slots
❑
Replacing burnt fuses
Reconfiguring the Voltage
You can configure the fan voltage for either 120 or 240 volts AC, depending
upon the voltage your country uses. The current voltage is visible on the back
of the chassis, just below the power cord plug as shown in Figure 8.
Figure 8: Fuse and Power Locations
110V
240V
110V
240V
USE ONLY WITH
250V FUSE
110V
USE ONLY WITH
250V FUSE
110V
USE ONLY WITH
250V FUSE
110V
Fuse carrier
Spare fuse
Fuse board
Current voltage
Current fuse
