Allied Telesis AT+TQm5403, Installation Manual, Page: 38 / 58

Chapter 2: Wireless Access Point Installation
38
2. Using the mounting bracket as a template, mark the two key-hole slots
with a pencil in the location and orientation where you want to install
the access point. Refer to the arrows in Figure 9.
Figure 9. Mark and Pre-Drill Holes for Key-Hole Slots
3. Pre-drill the two marked locations for the keyhole slots on the
hard-surface ceiling or wall and install two M4 screws and anchors (if
required). Leave the screws loose enough so that the bracket can slide
under the screw head in Step 4.
Note
For a wooden wall or ceiling, use M4, 25.0 mm flat-head wood
screws and anchors if required. The screws and anchors are not
provided.
4. Insert the openings of the bracket key-hole slots under the two screw
heads and slide the bracket into narrow end of the key-hole slot
opening. Refer to arrows in Figure 10. Tighten the screws snugly onto
the bracket.
Figure 10. Mount Bracket On Screws Using Key-Hole Slots
Ceiling Wall
Ceiling Wall