Allied Telesis AT-SBx81CFC960, Installation Manual

Page: 168 / 324

Chapter 8: Installing the Transceivers and Cabling the Ports
168 Section II: Installing the Chassis
Figure 103. Attaching a Fiber Optic Cable to an SFP+ Transceiver in the
AT-SBx81CFC960 Controller Fabric Card
7. Repeat this procedure to install additional SFP+ transceivers in the
AT-SBx81CFC960 Controller Fabric Card.
8. If you are not building a stack with the VCStack Plus feature, do one of
the following:

To install and cable additional transceivers in the chassis, go to the
appropriate section in this chapter for instructions.
 After cabling all the ports in the chassis, go to Chapter 9,
“Powering On the Chassis” on page 171.
9. If you are building a stack with the VCStack Plus feature, do the
following:
 Double-check the wiring of the cables of the trunk between the
SFP+ slots of the controller cards of the two chassis to be sure
they are correctly connected. The possible wiring configurations
are given in “Cabling Configurations for the Trunk” on page 277.

Afterwards, go to “Powering On the Stack” on page 305.