Allied Telesis AT-SB*81CFC960, Installation Manual

Page: 178 / 356

Chapter 8: Cabling the Ethernet Line Cards
178 Section II: Installing the Chassis
Note
Do not remove the dust plug from an SFP+ slot if you are not
installing the transceiver at this time. The dust plug protects the line
card from dust contamination.
2. Slide the connector on the AT-SP10TW Cable into the slot until it
clicks into place.
To install the cable into an odd numbered slot in the AT-SBx81XS16
Line Card or AT-SBx81XLEM/XS8 Expansion Module, position the
release tab on top as you slide the connector into the slot. To install the
cable in an even numbered slot, position the connector so that the
release tab is on the bottom. Refer to Figure 105.
Figure 105. Installing the AT-SP10TW Cable in the AT-SBx81XS16 Line
Card or AT-SBx81XLEM/XS8 Expansion Module
To install the cable in the AT-SBx81XS6 Line Card, position the
release tab on top as you slide the connector into the slot. Refer to
Figure 106 on page 179.
Release Tab
Release Tab