Hardware Description
Wiring the Power Inputs
9
AT-IMC1000TP/SFP Industrial Gigabit PoE+ Media Converter
FIGURE 2-2 Top Panel of the Industrial Gigabit Media Converter
2.3 Wiring the Power Inputs
Please follow the steps below to insert the power wire.
FIGURE 2-3 Location of V+ and V- Contacts
1. There is a silk print for user to recognize the location of V+ and V- contacts on the device.
2. Insert the positive and negative wires into the V+ and V- contacts on the terminal block connector.
Note:
The wire gauge for the terminal block should be in the range between 12~ 24 AWG
3. To tighten the wire-clamp screws located at the bottom of the unit (see above picture) highlighted in red for pre-
venting DC wires loosing
