Allied Telesis AT-AR2010V, Installation Manual, Page: 50 / 64

Chapter 3: Installing the Router and Powering on the Router
50
Starting a Local Management Session
This procedure requires a terminal or a terminal emulator program and the
management cable that comes with the router. To start a local
management session on the router, perform the following procedure:
1. Connect the RJ-45 connector on the management cable to the
Console port on the front panel of the router, as shown in Figure 25.
Figure 25. Connecting the Management Cable to the Console Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
 Baud rate: 9600 bps (9600 bps, 14400 bps, 19200 bps, 28800 bps,
38400 bps, 57600 bps, 115200 bps. The default is 9600 bps.)

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
CONSOLE FAULT
PWR
FNC1
FNC2
RESET
FDX
HDX
COL
READY
FAULT
MASTER
STANDBY
BYPASS
ETH1
WAN
2
ETH
CONSOLE
1000 LINK
ACT
100 LINK
ACT
FDX
HDX
COL
FAULT
PWR
FNC1
FNC2
READY
FAULT
RESET
DC 12-24V