Allied Telesis AT-8100L/8POE, User Manual

Page: 314 / 330

Chapter 25: LLDP and LLDP-MED
314
Displaying LLDP and LLDP-MED Settings
To display the LLDP and LLDP-MED settings, use the following
procedures:

“Displaying the Basic LLDP Configuration” on page 314

“Displaying LLDP Port Assignments” on page 315

“Displaying Port Locations” on page 316

“Displaying LLDP TLV” on page 316

“Displaying LLDP-MED TLV” on page 318
For information about configuring LLDP and LLDP-MED, see “Assigning
LLDP Locations to a Port” on page 302.
Displaying the
Basic LLDP
Configuration
To display the basic LLDP configuration, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122 on
page 284.
2. From the Discovery & Monitoring tab, hover over LLDP .
The LLDP tab appears to the right.
3. From the LLDP tab, select Basic Configuration .
The LLDP Configuration page is displayed. See Figure 123 on page
285.
The following fields are displayed:

Status — Indicates whether LLDP is enabled or disabled on the
switch.

Timer — Transmit interval.

Fast Start Count — Fast start count for LLDP-MED. The fast start
count determines how many fast start advertisements LLDP sends
from a port when it begins sending LLDP-MED advertisements
from a port, for instance, when it detects a new LLDP-MED
capable device.

Holdtime Multiplier — Holdtime multiplier value. The transmit
interval is multiplied by the holdtime multiplier to give the Time To
Live (TTL) the switch advertises to the neighbors.

Non Strict Med TLV Order Check — Indicates whether the switch
accepts LLDP-MED advertisements when the TLVs are not in the
standard order, as specified in ANSI/TIA-1057.