AT-x220-28GS Switch Installation Guide
23
Installing the switch on a table or a desktop
Here are the guidelines to selecting a suitable site for desktop or table use:
Review the procedure “Selecting a site for the switch” on page 21
to verify that the selected site is suitable for your switch.
The rubber feet included in the packaging should be attached to
the switch for table or desktop installation.
If your switch does not already have rubber feet fitted, fit these as follows:
1. Turn the switch over and place it on a table.
2. Remove the rubber feet, rivet pins and rivet housings from the
packaging.
Note
The feet are reusable. If they have been used previously, they may
be already assembled, with the rivet locked in place. To re-use
them, first push the rivets out of the feet. Then separate the rivet pin
and housing from each other, so that you can insert them as
described below.
3. Assemble the rivets by inserting the
Pin
into the
Housing
as shown in
Figure 9. Assembling the rivets
Insert all rivet pins into the rivet housings
Note
Do
not
press the pin all the way down to lock the rivet.If you do
engage the rivet lock, prise the pin out of the housing, so you can re-
assemble and re-use it.
Summary of Contents for AT-220-28GS Series
Page 8: ...vi ...
Page 10: ...viii ...
Page 26: ...Chapter 1 Overview 16 ...
Page 52: ...Chapter 2 Installation 42 ...
