Hardware Reference
5
C613-03086-00 REV G
AR415S Secure Modular Router
Each AR415S router provides:
■
four 10/100 Mbps full duplex, Layer 2 LAN Ethernet switch ports
■
one 10/100 Mbps full duplex, WAN Ethernet port
All LAN and WAN ethernet ports autonegotiate speed, duplex mode and
MDI/MDI-X. However, on the LAN switch ports you can use the software
to set these to a fixed configuration. If you turn off the Auto-MDI feature,
the ports are hard-wired as MDI-X. Software can also force a switch port to
either MDI or MDI-X.
■
one asynchronous port (ASYN0)
The RS-232 (V.24) asynchronous serial port (ASYN0) has an RJ-45
connector,
is wired as a DTE port, and can be used as a general purpose port for
terminals, printers or modems. For pin wiring and default communication
settings, see
“Asynchronous Interfaces” on page 17
.
■
one PIC bay
Front and rear panels of the AT-AR415S router are shown in the following
figure.
Hardware Features
■
266 MHz RISC processor
■
32 MBytes of SDRAM
■
16 MBytes of flash memory (1 MByte reserved for boot block code)
■
802.1Q tagged VLAN support
■
universal AC power supply
■
on-board hardware encryption processor for DES, 3DES and AES (Some
encryption options may require feature licenses.)
Port Interface Card
bay
The PIC bay can accommodate any of the following PICs:
•
AT-AR020 PRI E1/T1 PIC, one primary rate E1/T1 port
•
AT-AR021S (V2) BRI-S/T PIC, one basic rate ISDN S/T port
•
AT-AR022 ETH PIC, one Ethernet LAN AUI/10BASE-T port
PIC
SWITCH PORTS
1
2
3
4
SYS
0
ETH
PWR
STATUS
AR415S
Secure Modular Router
FULL
L/A
100M
FULL
L/A
100M
POWER
ON
OFF
POWER
SWITCH PORTS
ASYN0
ETH0
PIC BAY0
3
1
4
2
100-240 VAC
50/60 Hz
1.0 A