34
Release Note
Software Release 2.3.1
C613-10325-00 REV B
Bandwidth Limiting
This feature will be available on Rapier i Series layer 3 switches only, when
these models become available.
Ingress and egress bandwidth limits are specified separately. Limits can be
configured for each switch port using the command:
SET SWITCH PORT=
port-list
[INGRESSLIMIT={NONE|DEFAULT|0|64..127000|8..1016}]
[EGRESSLIMIT={NONE|DEFAULT|0|1000..127000|8..1016}]
where:
■
port-list
is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 and end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
The INGRESSLIMIT parameter specifies the maximum bandwidth for traffic
ingressing the specified port(s), in kbps (10/100 Mbps ports) or Mbps (Gigabit
ports). If NONE or 0 (zero) is specified, ingress limiting is disabled for the
specified port. For 10/100 Mbps ports the input value (64..127000) in kbps is
rounded down to the nearest 64kbps if below 1000, otherwise it is rounded
down to the nearest 1000 (or 1 Mbps). For Gigabit ports the input value
(8..1016) in Mbps is rounded down to the nearest 8 Mbps. The default is
NONE.
The EGRESSLIMIT parameter specifies the maximum bandwidth for traffic
egressing the specified port(s), in kbps (10/100 Mbps ports) or Mbps (Gigabit
ports). If NONE or 0 (zero) is specified, egress limiting is disabled for the
specified port. For 10/100 Mbps ports the input value (1000..127000) in kbps is
rounded down to the nearest 1000 (or 1 Mbps). For Gigabit ports the input
value (8..1016) in Mbps is rounded down to the nearest 8 Mbps. The default is
NONE.
Errata: Telnet Server
The following commands can be used to disable or enable the Telnet Server,
and to show information about its current settings. These commands apply to
current and previous releases, and will appear in the next revision of the
Software Reference for all models.
DISABLE TELNET SERVER
Syntax
DISABLE TELNET SERVER
Description
This command disables the Telnet server from being accessed remotely. The
Telnet server is enabled by default.
