Allied Telesis ANC10 Series, Installation And User Manual

Page: 60 / 124

Chapter 4: Modifying Advanced Properties
60
Flow Control
The Flow Control property allows you to control the flow between the
ANC10 network interface card port and its link partner. You can enable or
disable the network interface card port to process received PAUSE frames
and transmit PAUSE frames.
To specify or change the Flow Control feature, do the following:
1. Access the Advanced Properties.
See “Accessing Advanced Properties” on page 54.
2. Select Flow Control in the Property box.
The Flow Control window is displayed as shown in Figure 26.
Figure 26. Flow Control Window
3. Select one of the following options if available:

Auto Negotiation — The network interface card uses flow control
if it receives PAUSE frames on its ports from its link partner.
Otherwise, the network interface card does not use flow control.
This is the default.

Disabled — The network interface card ignores PAUSE frames.

Tx & Rx Enabled — The network interface card processes ingress
PAUSE frames and transmits PAUSE frames.