Allice Messtechnik R&S ZND, User Manual, Page: 827 / 1252

Command reference
R&S
®
ZND
827 User Manual 1173.9557.02 ─ 61
Parameters:
<Scope> GLOBal | CHANnel
CHANnel
–
when all the sweeps for each channel are complete
GLOBal
–
when all sweeps in all channels are complete
Note:
*RST
or "Preset" do not change the configuration of the
Universal Interface. Use
CONTrol:HANDler:RESet
to restore
default values.
*RST:
n/a (default: GLOBal)
Example: See
CONTrol:HANDler:PASSfail:MODE
CONTrol:HANDler:PASSfail:STATus?
Returns the global pass/fail status of the last measurement.
Return values:
<Status> PASS | FAIL | NONE
PASS
–
all measurements that are not in single sweep mode (on
hold) have been swept, and all limit checks have been passed.
FAIL
–
all measurements that are not in single sweep mode (on
hold) have been swept, at least one limit check failed according
to the specified pass/fail policy (
CONTrol:HANDler:
PASSfail:POLicy
).
NONE
–
no pass/fail status available, e.g. because the measure-
ment is in progress or because no limit check has been defined.
*RST:
n/a
Example: Preparations: Configure and enable a limit check. Start a mea-
surement and wait until the sweep is complete.
CONTrol:HANDler:PASSfail:STATus?
Query the result of the global limit check.
Usage: Query only
CONTrol:HANDler:RESet
Restores the default states of the
CONTrol:HANDler...
commands including the
data port values.
Example: See
CONTrol:HANDler[:EXTension]:INDex:STATe
Usage: Event
CONTrol:HANDler:SWEepend <SweepEnd>
Specifies the event that will cause the /SWEEP END line (pin 34) to go low; see Chap-
ter 12.3.4.4, "Timing of control Signals" , on page 1203.
Parameters:
<SweepEnd> SWEep | CHANnel | GLOBal
SCPI command reference
www.allice.de Allice Messtechnik GmbH