ALLIANCE ZEM477-3000, Service Manual

Page: 8 / 78

-
AWARNING-----------------------------�
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
2. NEUTRAL AT TERMINAL BLOCK TO REAR BULKHEAD AND FROM REAR BULKHEAD TO CONTROL
HOUSING, Figure 2 (Electric Models Only).
DR096-GO
Figure 2
3. POWER CORD TO REAR BULKHEAD AND FROM REAR BULKHEAD TO CONTROL HOUSING. WALL
RECEPTACLE POLARITY CHECK, Figure 3 (Gas Models Only).
NOTE: A qualified electrician should check the polarity
of the wall receptacle. If a voltage reading is measured
other than that illustrated, the qualified electrician should
correct the problem.
NEUTRAL
SIDE
Figure 3
(120 VOLT, 60 HERTZ
MODELS ILLUSTRATED)
GROUND
WIRES
OR099-GO
D502009 7