ALLIANCE SWNNC2HP115TQ01, Original Instructions Manual

Page: 68 / 90

Collecting Audit Information
This feature allows the owner to retrieve audit information stored
in the washer by pressing a sequence of pads on the control.
How to Enter Audit Feature
There are two methods the owner can use to enter the Audit Fea-
ture.
Entering the Audit Feature by Manual
Mode
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode .
2. Press the DELICATES (
∧
) or the COLD (
∨
) keypad to scroll
through the programmable options until
AUdit
appears in the
display.
3. Press the START keypad and
CyCLES
will appear in the dis-
play.
Entering the Audit Feature with the
Coin Vault Open
1. Open coin vault. Make sure service door is closed.
2. Press the START (enter) keypad.
How to Read Audit Data
1. Press the DELICATES (
∧
) or the COLD (
∨
) keypad to scroll
through the programmable options. Refer to Table 13 .
2. When the desired option appears in the display press the
START (enter) keypad. The current value will appear in the
display.
3. Press the WARM keypad. The display will return to the audit
option list.
Programmable Options
CyCLES
Total Number of Machine
Cycles
Coin 1
Total Number of Coins #1
Coin 2
Total Number of Coins #2
PULSE
Total Number of Start Pulses
rAPCyC
Total Number of Rapid Ad-
vance Cycles
rUnHrS
Total Number of Run Hours
rCoin1
Resettable Coin #1 Count
Table 13 continues...
rCoin2
Resettable Coin #2 Count
rCyCLE
Resettable machine Cycle
Count
Table 13
How to Exit Audit Feature
1. Press the WARM (<) keypad until the control returns to
Ready Mode.
2. To exit Audit Feature when using Coin Vault Open method,
owner must close coin vault. The control will then return to
Ready Mode.
Collecting Audit Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
68 Part No. 204370ENR1