ALLIANCE Quantum Platinum, Programming

Page: 19 / 82

4. Press the keypad to modify the cycle to a Speed Cycle .
5. Press the keypad to select the highlighted cycle options.
6. Follow the prompts to add or reject cycle modifiers.
7. If not in
OPL Mode or in a Lucky Cycle , satisfy the vend.
8. Press the keypad to start the cycle.
NOTE: If door is not closed when the keypad is
pressed, the display shows the
Close Door Menu .
Perform additional keypad presses to access optional menus:
• Simultaniously press the and keypads with the Service
Door open and the Coin Vault closed to enter the System
Menu .
• Press the keypad to enter the
Operating Instructions Menu .
• Press the keypad to enter the Language Selection Menu .
• Press the keypad with the Coin Vault open and the Service
Door closed to enter the Audit Data Menu .
Delayed Start Setup Menu
Figure 9
This feature allows the user to start a cycle at a later time. This
mode is only manually accessible if OPL Mode and Delayed
Start Mode are enabled (refer to
Globals Menu ). The door must
be closed.
Press the keypad to increase or keypad to decrease the num-
ber of hours the cycle is delayed up to a maximum of 72 hours.
Press the keypad to start the Delayed Start countdown.
Close Door Menu
Figure 10
The control displays the Close Door Menu when entering Start
Mode or Pause Mode with the loading door open. Close the door
and press the keypad to start or resume the cycle.
Run Menu
Run Menu displays the cycle name, cycle progress and remaining
cycle time while the machine is operating. Refer to
Figure 11 .
Cycle progress is indicated by a three-dot sequence.
Figure 11
If the Modifier Prompt programming option is enabled, the user
will be prompted to add modifiers to their cycle at these times:
• Five seconds after a valid cycle selection change from any
mode (this is including Additional Vend mode from Start and
Run mode)
Machine Cycle Definition and Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
19 Part No. 806526ENR2