ALLIANCE Automaatic washer, Installation & Operation Manual

Page: 27 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 25
210193
Maintenance
User-Maintenance Instructions
Cold Weather Care
If the washer is delivered on a cold day (below
freezing), or is stored in an unheated room or area
during the cold months, do not attempt to operate it
until the washer has had a chance to warm up.
Care of Your Washer
Use only a damp or sudsy cloth for cleaning the
control panel. Some spray prewash products may harm
the finish on the control panel.
Wipe the washer cabinet as needed. If detergent,
bleach or other washing products are spilled on the
cabinet, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Do not use scouring pads or abrasive cleansers.
The washtub will need no particular care though it
may need rinsing or wiping after an unusual load has
been washed. This also may be necessary if too little
detergent has been used.
Leave the loading door open to allow the inside of the
washer to dry out after use. This helps prevent musty
odors from developing.
Vacations and Extended Non-Use
IMPORTANT: To avoid possible property damage
due to flooding, turn off the water supply to the
washer whenever there will be an extended period
of non-use.
Reinstallation of Shipping Materials
Shipping Brace
The shipping brace in the lid opening should be saved
and reinstalled whenever the washer is moved. To
reinstall the brace, open the washer lid and place the
brace over the washer agitator, placing the back of the
brace into the lid opening first.
Shipping Plug
The plastic shipping plug should be saved and
reinstalled any time the washer is moved. The plug fits
into two openings: The base opening and the shipping
plug opening on the bottom of the movable pivot
dome. The plug MUST be inserted into both openings
to prevent damage to the washer. In order to accomplish
this, the shipping plug opening must be directly lined
up with the base opening. Refer to
Figure 30 .
Figure 30
Motor Overload Protector
This internal overload protector will stop the motor
automatically in the event of an overload. The
overload protector will reset itself in two or three
minutes and the motor will restart automatically. If the
overload protector stops the motor again, remove the
washer from use and call the service person to correct
the problem.
W544I
1 Shipping Plug Opening
2 Base Opening
3 Shipping Plug
3
1
2