WARNING
Before you start, turn off the main switch to avoid
possible injuries!
C216
To adjust the spring unit, turn both nuts with the same number of
turns simultaneously on the guiding rods of the spring unit. Refer
to
.
35 - 60 kg / 350 - 600 L Models
CZW24N
1.
Spring unit
2.
Adjusting nuts
3.
Guiding rods
4.
Suspended part
5.
Machine frame
6.
Spring suspension eyes
Figure 47
The adjustment is correct when a gap (X = 2.16 in. [55 mm]) ap-
pears in all four corners of the suspended machine part, between
the plate edge of the vibrating part and the frame top surface.
Replacement Washer Fuses
Fuse Values
The correct values of fuses can be found in the vicinity of the
fuse holders and on the electrical scheme and delivered with the
machine. When a fuse is blown, you can replace it with the same
value but in NO case should you replace it with a fuse of higher
value. If the fuse blows again, do not change it but find the cause
of the failure. Contact your commercial distributor for help if
necessary.
Earth Leakage Trips
If the laundry is equipped with an earth leakage trip in the inlet
circuit of the electric switchboard, it is necessary to test it regu-
larly. The earth leakage trip is a very sensitive device, and it pro-
vides a safety for operators avoiding a risk of electric shock while
the machine is in operation.
WARNING
A qualified technician must test the earth leakage
trip (ground) function at least once every 3 months.
C219
To test the earth leakage trip, press the test push button of the
earth leakage trip while it is under tension. The earth leakage trip
must go off.
Unblocking the Door Lock in Case of
Emergency
If a power blackout takes too long, you can make an emergency
unblocking of the door lock.
WARNING
Before emergency door opening, turn off the ma-
chine's main switch. Never open the door while the
drum is still running. Never open the door if “too
hot” is indicated. Risk of burn or scald injuries. Nev-
er open the door if the machine parts feel too warm.
Always wait to open the door until there is no water
in the drum. In the opposite case, it will flow out after
opening the door. Open the door only at the loading
side to prevent contamination of clean side linens.
C223
1. Verify if all conditions are present to safely open the door.
2. For 35 - 60 kg / 350 - 600 L Models , using a tool (e.g.,
screwdriver) and a piece of wire with maximum diameter of
0.21 in. [5.5 mm], insert the tool through the finger protection
hole into the lock cover and push softly. Refer to
.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
59
Part No. D2601EN
Summary of Contents for UY350 PROFORM TOUCH
Page 2: ......
