39201
37
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
26. AGITATOR
a. Open loading door.
b. Remove agitator by placing two agitator hooks,
No. 254P4P, under bottom edge of agitator.
Refer to Figure 29.
IMPORTANT: Hooks should be positioned 180
degrees from each other, and must be placed under
base of agitator near agitator vane for greater
stability. If hooks are placed between the vane area,
agitator damage may occur.
c. Using a rocking motion (back and forth)
carefully lift agitator off drive bell.
27. AGITATOR, DRIVE BELL AND SEAL
ASSEMBLY
IMPORTANT: If water is present in washtub, spin
and pump out before attempting to remove drive
bell.
a. Open loading door.
b. Remove agitator by placing two agitator hooks,
No. 254P4P, under bottom edge of agitator.
Refer to Figure 29.
IMPORTANT: Hooks should be positioned 180
degrees from each other, and must be placed under
base of agitator near agitator vane for greater
stability. If hooks are placed between the vane area,
agitator damage may occur.
c. Using a rocking motion (back and forth)
carefully lift agitator off drive bell.
d. Remove plug, screw (and “O” ring if present)
from top of drive bell.
NOTE: Use No. 294P4 Drive Bell Tool to remove
drive bell from transmission shaft.
NOTE: Drive Bell Tool, No. 253P4, must be
updated with Jaws, No. 294P4A, and Bolt, No.
294P4B, to remove drive bell.
e. Back bolt out of 294P4 Drive Bell Tool
approximately three quarters of the way.
Refer to Figure 30.
f. Place tool over drive bell, making sure indent
on jaws line up with wide slots on drive bell.
Refer to Figure 31.
Figure 29
W247SE1A
AGITATOR
NO. 254P4P
AGITATOR
HOOKS