39201
35
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
24. DRAIN HOSE ELBOW
a. Loosen hose clamp and remove drain hose from
elbow. Refer to Figure 26.
b. Remove screws holding elbow to rear of
washer cabinet. Refer to Figure 26.
c. Pull elbow out through opening in cabinet far
enough to loosen inner clamp, then remove
elbow from inner hose.
NOTE: When installing elbow on inner hose, DO
NOT allow hose inside of washer to twist! Direct
elbow toward drain receptacle and secure elbow to
washer cabinet.
25. LOADING DOOR
a. Open loading door. Refer to Figure 27.
b. Remove two screws holding left hinge to door
and remove hinge. Refer to Figure 27.
c. With loading door raised to vertical position,
swing left side of door toward front of washer.
Refer to Figure 28, procedure one.
d. Rotate loading door so door is upside down.
Refer to Figure 28, procedure two.
e. Remove loading door, right door hinge and
bushing from cabinet top. Refer to Figure 28,
procedure three.
NOTE: Reverse procedures when installing loading
door.
Figure 26
ELBOW
ATTACHING
SCREWS
W242SE1A
DRAIN
HOSE
HOSE
CLAMP
Figure 27
LOADING
DOOR
W287SE1A
HINGE
ATTACHING
SCREWS
RIGHT
HINGE
LEFT
HINGE