Alliance Laundry Systems NetMaster HC18NC2, Programming Manual, Page: 122 / 146

Programming NetMaster
F232152
120 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
110. Rinse Final Extract Drain
“+110”
This option allows the owner to program which drain
option will be used during Final Rinse Extraction for
all cycles.
How to Program Rinse Final Extract Drain
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “ PrOg ” appears in the VFD. Press
the START (enter) keypad and “ +001 ” will
appear in the VFD.
Figure 195
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “
+110
” appears in the VFD. Refer
to Figure 196.
Figure 196
4. When “
+110
” appears in the VFD, press the
START (enter) keypad. The current drain output
value for the Rinse Final Extract Drain will
appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current output
value displayed in the VFD to the desired output
value. Refer to Figure 197.
NOTE: Default output value is 002.
Figure 197
6. Press the START (enter) keypad when the correct
value appears in the VFD. The next option,
“
+111
”, will appear in the VFD.
NOTE: To program “
+111
” (Spin Extract Drain),
refer to option 111. To program other options, refer
to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM153N
COM153N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2