Alliance Laundry Systems NetMaster HC18NC2, Programming Manual

Page: 118 / 146

Programming NetMaster
F232152
116 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
108. Rinse Final Fill/Tumble Drain
“+108”
This option allows the owner to program which drain
option will be used during Final Rinse Fill and Tumble
for all cycles.
How to Program Rinse Final Fill/Tumble
Drain
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “ PrOg ” appears in the VFD. Press
the START (enter) keypad and “ +001 ” will
appear in the VFD.
Figure 189
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “
+108
” appears in the VFD. Refer
to Figure 190.
Figure 190
4. When “
+108
” appears in the VFD, press the
START (enter) keypad. The current drain output
value for the Rinse Final Fill/Tumble Drain will
appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current output
value displayed in the VFD to the desired output
value. Refer to Figure 191.
NOTE: Default output value is 001.
Figure 191
6. Press the START (enter) keypad when the correct
value appears in the VFD. The next option,
“
+109
”, will appear in the VFD.
NOTE: To program “
+109
” (Rinse Final Drain/
Tumble Drain), refer to option 109. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM151N
COM151N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2