Alliance Laundry Systems LTZ87A*H0902 Series, Installation Instructions Manual

Page: 20 / 70

Installation
800941
18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 9: Plug In the Unit
Refer to sections on Electrical Requirements and
connect the unit to an electrical power source.
Figure 17
Figure 18
Step 10: Check Installation
Refer to Installer Checklist on the back cover and
make sure that unit is installed correctly.
Moving Unit to a New Location
To prevent damage while moving the washer, the
shipping materials MUST BE reinstalled.
Reinstallation of Shipping Materials
Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to
Figure 19 .
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and lockwashers.
Refer to
Figure 19 .
Reinstall front access panel.
Figure 19
Refer to step 7 for proper procedures whenever the
washer is moved.
D373I
1 Power Cord (Four-Wire)
D254I
ELECTRIC UNIT
Connect to 40 Amp circuit.
1
D254I
GAS UNIT
Plug cord into separately fused 20 Amp circuit.
H336I
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
2
1
4
3