80
801805
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
54. CABINET TOP
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 27.
b. Gently lower access panel to disengage panel
locators from bottom edge of access panel.
Refer to Figure 27.
c. Remove two screws holding bottom tabs on
front panel to dryer cabinet. Refer to Figure 28.
d. Swing bottom of front panel away from dryer to
disengage hold-down clips and locators from
cabinet top.
e. Disconnect wires from door switch. Refer to
NOTE: Refer to wiring diagram when rewiring
switch.
f. Remove two screws holding cabinet top to front
flange of cabinet. Refer to Figure 29.
g. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 30.
NOTE: While servicing, cabinet top may be raised
and hinged on the rear hold-down brackets or
supported against wall behind dryer.
Figure 28
SWD1674S
Front Panel
Attaching
Screws
Figure 29
Figure 30
D394S
Cabinet Top
Hold-Down Screws
Cabinet
Top
D352SE1A
Rear
Hold-Down
Brackets
