801805
107
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
Section 6
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
80. CABINET LEVELING LEGS
a. Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on
any type of carpeting is not recommended.
b. Loosen locknuts and adjust the leveling legs
until the washer does not rock. Refer to
Figure 58.
c. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
d. Place rubber feet on all four leveling legs. Refer
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION
Figure 58
SWD601N
Leveling
Leg
Level
Washer
Base
Locknut
Rubber
Foot
