53264
49
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 6
Adjustments
67. TIMER KNOB INDICATOR
a. With timer knob indicator in top OFF position,
push in and hold start switch button. Slowly
turn timer knob clockwise only until dryer
starts. Then immediately open the loading door
to stop dryer.
b. If dryer starts with indicator still in the OFF
position, proceed as follows:
(1) Hold knob firmly and move indicator and
plate one “click” in a clockwise direction.
(2) Check position in reference to the right
hand vertical line of the OFF position.
(3) If the indicator is still in the OFF portion of
dial, move it one more “click” in a
clockwise direction.
(4) Repeat this adjustment until the indicator is
on the right hand vertical line of the OFF
position.
c. If dryer starts with indicator past the right hand
vertical line of the OFF position, follow
instructions in “Step b” above EXCEPT move
indicator and plate in a counterclockwise
direction one “click” at a time until indicator
and right hand vertical line of OFF position
match up.
68. LEVELING LEGS
a. Threads locknuts down to heads of leveling
legs, then thread legs into dryer base until head
extend out of base approximately 3/4 inch.
Refer to Figure 41.
b. Turn legs in or out of base as necessary to level
dryer. All four legs must rest firmly on the
floor.
c. Tighten locknuts securely against dryer base.
Refer to Figure 41.
Figure 41
DRY868S
DRYER
BASE
LEVELING
LEG
LOCKNUT
