53264
35
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
43. DOOR SWITCH
a. Remove front panel. Refer to Paragraph 31,
steps “a” through “c”.
b. Depress tabs on top and bottom of switch and
push out of front panel. Refer to Figure 22.
(Refer to appropriate wiring diagram when
rewiring switch.)
44. CYLINDER LIGHT
a. Open loading door and remove bulb through
top opening in the front bulkhead by pushing up
and turning bulb to the left. Refer to Figure 23.
45. CYLINDER LIGHT RECEPTACLE
a. Remove front panel. Refer to Paragraph 31,
steps “a” through “c”.
b. Disconnect wires at connectors.
c. Remove two Phillips head screws and
lockwashers holding receptacle to front
bulkhead. Refer to Figure 23.
Figure 22
D240S
DOOR
SWITCH
TABS
To Test Door Switch:
1. Disconnect wires from door switch.
NOTE: Refer to appropriate wiring diagram
when rewiring switch.
2. Set meter to read Ohms and apply meter probes
on switch terminals 1 and 3 with door closed.
You should get “zero” reading.
3. Apply probes to terminals 1 and 2 with door
closed. The meter should read “infinite.”
4. Open door. Meter should read “infinite”
between 1 and 3 and “zero” between 1 and 2.
Figure 23
DRY852S
CYLINDER
LIGHT
PHILLIPS
HEAD
SCREWS
