Alliance Laundry Systems 802749r1, Instalation Instructions, Page: 8 / 12

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749
8
Step 7: (Supply Injection Models Only)
Connect External Supplies to Washer
IMPORTANT: Undiluted chemical dripping can
damage the washer.
1. Remove two nozzles from accessories bag. Use
either the 3/8 inch or 1/4 inch nozzles, depending
on the diameter of the dispenser tubing used.
2. Attach nozzles to rear of machine. Connection
point located on cabinet, above water mixing
valve. Refer to
Figure 11 .
3. Connect supply hoses to nozzles and secure with
hose clamps (obtain locally). Refer to Figure 11 .
NOTE: Hoses can be connected to either nozzle.
4. Refer to supply injection system instructions and
label inside washer junction box cover
(
Figure 12 ) for electrical connection.
Do not attempt to make supply injection electrical
connections to points other than those provided
specifically for that purpose by the factory.
5. Refer to supply injection system instructions for
details on operation.
A junction box on the rear panel houses a terminal
strip which furnishes supply output signals for the
supply injection pumps. Refer to
Figure 12 for the
injection interface label.
Supply Injection System
Number of liquid supply connections
(1–Detergent and 2–Softener) 2
Liquid supply connection size,
in. (mm) 3/8 (9.52)
or
1/4 (6.35)
Wear eye and hand protection when
handling chemicals; always avoid direct
contact with raw chemicals. Read the
manufacturer’s directions for accidental
contact before handling chemicals. Ensure
an eye-rinse facility and an emergency
shower are within easy reach. Check at
regular intervals for chemical leaks.
SW016
WARNING
FLW2162N
1 Injection Point
2 Nozzle
3 Supply Dispenser Pump Outlet
Figure 11
FLW2028N
Figure 12
2
1
3
DETERGENT
DISPENSER
CONNECTION
SOFTENER
DISPENSER
CONNECTION
SOFTENER
RELAY
DETERGENT
RELAY
CHEMICAL INJECTION
ELECTRICAL INTERFACE
NO CONNECTION
TERMINAL
BLOCK
YELLOW
YELLOW/BLACK
RED
RED/BLACK
801653R1
NOTE: Normally Open Contacts.
Contacts Close to Start Chemical Injection.
Maximum Load Connection per Contact:
1A @ 120VAC/240VAC