ALL
FASTENERS.COM
|
17
()
19. REMOVING THE NAILS
1.
Pull the feeder knob backward to leave the nails some
distance and press the knob of the nail feed.
The nails will fall back on end of magazine catch location.
2.
Using your finger, press the catch and let
the nails drop into the palm of your hand.
Catch
20. OPERATING NAILER
Read section titled “2. SAFETY WARNINGS” before operating tool.
DANGER
Operators and others in work area MUST wear safety glasses with side shields that conform to safety
regulation specifications.
Never use in presence of flammable liquids or gases.
DO NOT touch around the exhaust outlet with bare hands. The push lever and nose will become hot
after prolonged or rapid use.
DO NOT allow the movement of the push and pull lever with hands. This could cause accidental firing
and possible injury.
Explosion and fire hazard. Keep away from sunshine and temperatures exceeding 120°F (50°C).
Keep away from ignition source.
No smoking.
WARNING
NEVER POINT tool at yourself or others in work area.
Keep fingers AWAY from trigger when driving nails to avoid accidental firing or injury.
Use outdoor or well-ventilated work area.
DO NOT inhale its contents.
DO NOT use the electrical cord if damaged. Have it repaired immediately.
Never place your face, hands or feet closer than 8 inches (200mm) from firing head when operating.
DO NOT drive nails on the top of other nails or with nailer at too steep of an angle; nails could ricochet
and cause injury
DO NOT drive fasteners into thin boards or near corners and edges of work surface. By doing so, the
fasteners could be driven through or away from the work surface and cause injury to operator or others.
Never drive fasteners from both sides of a wall at the same time. By doing so, the fasteners could be
driven into and through the wall and cause injury to operator or others on opposite side of wall.
Never use nailer which is defective or operating abnormally.
120°F
(50°C)
Maximum
Nail Feeder
Feeder Knob
Catch
