allen AR16, Operations & Parts Manual

Page: 30 / 114

1. Never allow your (LP) Liquid Propane-gas container to be filled above the maximum safe level
as indicated by a scale or the fixed liquid level gauge (outage). Do not use the visible gauge for
filling.
2. Do not use a wrench or pliers to close the service valve or fixed liquid level gauge. These
valves are designed to be closed leak-tight by hand or screw-driver as appropriate. If wrenches
are necessary to stop a leak, the valve needs repair or replacement.
3. When tightening the POL Nut (left hand thread) on the service valve, draw it up snug with a
proper wrench. This is a machined male brass fitting which seats securely against a female seat
in the POL valve - no pipe dope is necessary.
4. Acme/Type 1 valves have right handed threads which are secure when hand tight, and on the
Quick Disconnect/Type 2 Valves, the male connection is inserted into the female connection on
the cylinder valve. (No wrenches required for the Acme or the Quick Disconnect.)
5. When using container, slowly open service valve all the way. Listen to the regulator. A contin-
uous hiss or “clicking” sound may indicate a leak or an open valve on an appliance.
6. Check all tanks and the line connections periodically to be sure they are tight. When testing for
leaks, use an approved ammonia-free leak detector solution, not matches.
7. Make certain your container is properly fastened in place.
8. Turn container with open part of container guard towards trailer (travel trailer installation). This
protects valves and regulator against flying rocks and mud. Transport container in the proper
position in which it is used, with the valves closed and POL plugs inserted for POL valves or dust
caps for ACME valves. Secure the tank against falling or rolling.
9. Check for leaks after connecting. Apply approved leak detector solution to connection, turn off
all burners and pilots, and open service valve. Leaks will be detected by the growth of the bub-
bles. If bubbles grow, tighten or repair the connection as needed. Repeat leak test until problem
is corrected.
10. LP-gas is normally non-corrosive; you need not worry about the inside of your container.
However, the outside should be kept free from rust by a periodic coat of paint in a light reflective
color. It is very important to inspect and maintain the bottom and foot ring on the container.
11. Do not store LP-gas containers indoors or in en-closed areas. Do not expose LP-gas con-
tainer to heat. Always store with service valve closed and plugged or capped as required.
12. Do not attempt to repair any containers, container valves, regulator or appliances by yourself.
Use only trained certified LP-gas service personnel to perform repairs.
1.5 - Propane Operating Safety
SECTION 1
SAFETY
055838 Page 30