The cutting height of your mower has been set at the highest position (1).
If you prefer a lower cut follow these instructions:
a. Turn the petrol tap to the off position.
b. Disconnect the spark plug lead.
c. Turn the mower on its left hand side, keeping the carburetor uppermost.
d. Wearing protective gloves remove the flexiblade/cutterbar.
e. Remove the retaining bolt with the spanner provided whilst holding the
blade or disc. Make sure your hands are adequately protected from the
cutting edge.
f. Reposition the spacers as required. See diagrams for cutting device
option.
Note for the 446 Hovertrim: One spacer is required above the disc at
all times.
NOTE: The large spacer must be positioned directly below the impeller at
all times.
TIGHTEN THE BLADE RETAINING BOLT - USE ONLY THE SPAN-
NER PROVIDED.
To prevent accidents, thoroughly inspect the area and remove all
objects which when contacted by the mower cutterbar could become
dangerous projectiles. Inspect the area for hidden obstructions which
when contacted by the cutterbar could risk health and safety or result
in damage to the mower. Remember the location of these obstructions
and ensure that you mow around them.
1.16
OPERATING THE
1
2
Adjusting the Cutting Height
305113
Before Mowing
HAY-G00003-A
1
2
3
4
305113
Flexiblade 446
Cutterbar 450 / 453
High
Low
High
Low
MACHINE
111-2596 (A) 23/7/08 3:27 pm Page 1.16
