5
ASSEMBLY INSTRUCTIONS FOR PLUG-IN INSTALLATION
1.
Turn off the circuit breakers and the wall switch to the
supply line leads.
DANGER:
Failure to disconnect the power
supply prior to installation may result in serious injury
or death.
2.
This fixture has two options for installation. To install
the fixture using the plug-in method, continue to the
next step.
To install the fixture without the plug, skip to
ASSEMBLY INSTRUCTIONS FOR HARDWIRE
INSTALLATION, page 8.
Note:
Hardwire installation
requires an outlet box at the installation location.
3.
Determine the desired location of the fixture assembly
(A) making sure you have access to an electrical
outlet and there are no electrical lines or plumbing
where you intend to attach the mounting hardware.
Mark the anchor (AG) locations on wall and drill each
hole 7 mm in diameter. Insert the anchors (AG) and
tap into the wall until secure. Using a screwdriver,
set two screws (AH) into the anchors (AG) leaving
enough exposed to set into the keyhole slots on the
preassembled wall plate (E).
Hardware Used
AG
Anchor
x 2
Anchor Screw
x 2
1
3
AG
AH
2
Plug-in
Hardwire
AH
