10
ASSEMBLY INSTRUCTIONS FOR HARDWIRE INSTALLATION
7. To remove the power cord (G) from the fixture (A),
locate the two wires extending from the power
cord (G). Lift the lever on the wire connectors
preassembled to the fixture wires to release each
plug wire. Once both wires of the power cord (G) are
released, pull it through the grommet (I) at the bottom
of the fixture (A) to remove.
8. Remove the hex nut preassembled to plug button
(EE). Then insert the plug button (EE) through
grommet (I) and secure with the hex nut.
Hardware Used
EE
Plug Button
x 1
9. Make the following wire connections using the wire
connectors preassembled to the fixture (A) wires:
• Push the Bare/Green (ground) supply wire into the
empty wire hole of the wire connector preassembled
to the Copper wire. Lower the lever to secure.
• Push the White (neutral) supply wire into the empty
wire hole of the wire connector preassembled to the
White wire. Lower the lever to secure.
• Push the Black (hot) supply wire into the empty
wire hole of the wire connector preassembled to
the Black wire from the switch. Lower the lever to
secure.
Note:
If household supply wires are different
colors than referred to above, it is recommended a
professional electrician determines the proper wiring.
9
8
White
(neutral)
White
Black
Black
(hot)
Copper
Outlet
Box
Hex Nut
Bare/Green
(ground)
7
A
EE
I
Lever
G
I
A
