SLC 5/03™, SLC 5/04™, and SLC 5/05™ Modular Processors
7
Publication 1747-IN009C-MU-P - December 2002
Installation Procedure
Install the Processor
Make sure system power is off; then insert the processor into slot 0 of the 1746 chassis.
Apply Power to the Processor
1.
Energize the chassis power supply.
2.
Check the chassis power supply and processor LEDs. The power LED on the power
supply should be on and the fault LED on the processor should be flashing. See the
figure on page 8 for location of the power supply and processor LEDs.
IMPORTANT
The SLC 500 modular processors must be inserted into the left slot
(slot 0), as shown below. In addition, remove the protective wrap after
installing the processor.
Power Supply
Protective Wrap
Card Guide
Processor Release
