Rockwell Automation Publication 2711-IN021D-EN-P - October 2018
3
Power Terminal Block
Install the New Power Terminal Block
To install the power terminal block, follow these steps.
1.
Press the base of the power terminal block into position.
2.
Gently push the top of the terminal block back to the vertical position to snap in the
locking tab.
3.
Reconnect wires to the marked terminals on the terminal block.
4.
Restore power to the terminal.
Power Terminal Blocks With Two Screws
For power terminals with two screws, perform the following steps.
Remove the Existing Power Terminal Block
To remove the existing power terminal block, follow these steps.
1.
Remove power from the terminal.
2.
Disconnect wires from the marked terminals on the terminal block.
3.
Loosen the two screws that secure the terminal block.
4.
Gently pull the terminal block away from the connector.
Install the New Power Terminal Block
To install the new power terminal block, follow these steps.
1.
Attach the new terminal block to the connector until seated.
2.
Tighten the two screws to secure the terminal block to the connector.
3.
Reconnect wires to the marked terminals on the terminal block.
4.
Restore power to the terminal.
DC Terminal Block
AC Terminal Block