Power Supply Modules
(Cat. No. 1771-P4S, -P6S, -P6S1)
Installation Data
2
To configure the supply:
1.
Position the power supply module so that the jumpers and pins are
facing upward as shown in figure 1.
Figure 1
Power Supply Jumpers
2.
Set the jumpers as shown in table A. Use needle nose pliers to set the
jumpers.
Table A
Jumper Settings
For This Configuration
Set Jumpers to:
A single power supply in a powersupply chassis
connected to an I/O chassis through a power cable.
right position
All
other configurations. (Power supplies are
shipped with jumpers in this position.)
left position
Place the Power Supply in a Chassis
WARNING: Turn off all power-supply modules before
removing modules from or inserting modules into a chassis.
Failure to observe this warning could alter processor memory,
damage module circuitry, and cause unintended operation which
could possibly cause injury to personnel.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com