Installation Data
Auxiliary Power Supply
Cat. No. 1771P2
2
Mount the Power Supply
ATTENTION:
If you do not remove system power, you could
damage the module circuitry and/or cause undesired operation
with possible injury to personnel.
1.
Remove system power.
2.
Mount the power supply.
If Mounting Separately:
If Mounting on Left Side of Chassis:
use the rear flanges
to mount it to a panel.
Mount the power supply up to 5 cablefeet
from the I/O chassis.
11.25"
(285mm)
263mm
(10.37")
Depth is 182mm (7.16")
116mm
(4.56")
45mm
(1.8")
12593-I
Important:
Do not mount the power supply below
the I/O chassis.
19569
Use the four screws supplied with the I/O chassis
to install the power supply onto the I/O chassis.
flat washer
screw
Important:
Place the flat washers provided between each mounting
screw and the power supply. If you do not use the flat washers, the
mounting screw intrudes into the I/O chassis and interferes with
module insertion.