Allen-Bradley 1440-SDM02-01RA, User Manual, Page: 96 / 168

96 Rockwell Automation Publication 1440-UM001D-EN-P - September 2016
Chapter 2 Configure the XM-124 Standard Dynamic Measurement Module
1. To move the desired parameters to the ‘Custom assembly’ pane (right
side), click the left and right arrows between the panes.
2. To change the order of the parameters, click the up and down arrows.
3. Click OK.
The custom assembly is then presented as the assembly on the I/O
dialog box.
See Figure 44 .
Figure 44 - 1 Custom Assembly on I/O Tab
Module
Use this dialog box to view the module identity specifics, including its
DeviceNet address and communication rate. Depending on the DIP switch
settings, it can also be used to set the address and communication rate of the
module, as well as to update the firmware.
Identity
The identify section presents information that is read from the module. If no
module is connected, these values are blank. These values may be asked for
when discussing issues with the Rockwell Automation Technical Support
group.