Initial operation 9
Manual ADQ-610 series Rev. 1.0
Initial operation
2. Initial operation
2.1 Installing the board
Please read the manual of your computer prior installing the board regarding the installation of
additional hardware components.
Handling the board should be done with care to ensure that the device will not be damaged
by electrostatic discharge (ESD), mechanical stress or current surges. Ensure to take all safety
precautions to avoid an electric shock and follow the standard ESD safety precautions.
Follow this order of operation:
•
Unplug the mains plug of your PC system.
•
Open the housing as described in the manual of your PC system.
•
Make sure that electrostatic discharge cannot occur via the board when you plug it in. At
least one hand should be grounded in order to dissipate any static charge.
•
Only for PCI Express models: for the +5 V supply of the board an additional supply by the
PC power supply is neccessary (current consumption without load 300 mA typ.). Connect
a free power connector of your PC (e. g. as used for powering drives) with the appropriate
„MOLEX“ male connector of your PCIe board (see the following diagram). On demand ad-
apter (cables), e. g. from 13-pin SATA power supply male connector to 4-pin MOLEX female
connector are available in specialized shops.
+5 V (PC)
GND_PC
GND_PC
n. c.
Figure 1: 5 V supply for PCI Express models
Attention: If you take the board into operation without connecting the +5 V supply
the board can be irreverseable damaged!
Summary of Contents for ADQ-610 cPCi
Page 1: ...Manual Rev 1 0 EN ADQ 610 cPCI Isolated 4 or 8 channel voltage output board ...
Page 22: ...22 Appendix Appendix Manual ADQ 610 series Rev 1 0 ...
Page 31: ... 31 Manual ADQ 610 series Rev 1 0 ...
Page 32: ...32 Manual ADQ 610 series Rev 1 0 ...
