STEP 4. Attach Back Slats
•
Tip the swing so that it is resting on the 3 Back Posts and attach the
narrow top slat (G) along the top of the swing.
•
Using the 3/8” spacer evenly space and attach the remaining 6 slats
to the back posts starting from top slat down.
STEP 5. Attach Arms
•
Mount Arm Supports to side of the Swing using Carriage
Bolts.
•
Set front of arm over arm support and align rear arm with pre-
drilled holes in back post - make arm flush with back post and
attach arm using 2-1/2 inch screws.
•
Make inside of arm flush with arm support and attach arm to
arm support using 2-1/2 inch screws.
( glue is optional here)
STEP 6. Hardware Placement
NOTE: If you hanging distance is higher than 8 ft. you may require additional chain.
•
Use washers and hex nuts to install Eye-Bolts to the pre-drilled holes
located on each side of the swing.
•
Use a quick link to attach 2 pieces of chain to each side of your roof
beam or A-Frame. ( space 50 inches apart)
•
Insert the free ends of the chain through the guide holes on the arm
and attach to each eyebolt using quick-links.
(note: a hammer may be required to tap quick-link onto eyebolt)
•
To create a gentle incline raise the front of the swing by a link or two.
•
Your swing is ready for use.
♥
Thank you for choosing All Things Cedar
♥
