FAS-SLIDECH300BBUP SLIDING GATE OPERATOR
11
Setting obstruction force
If the door meet an obstruction during closing, it will stop and reverse about 15cm~20cm.
1. Press and hold
SET
. The LED will display number from
’
1
’ to ’
4
’, when the number ’
3
’ appears on the
LED display, release the
SET
.
2. Press
OPEN
to increase the obstruction force, the maximum force is level 9. Press
CLOSE
to
decrease force, the minimum force is level 1.
3. Press
SET
to confirm.
SET
CODE
CODE
SET
SET
CODE
Decrease obstruction force
Increase obstruction force
OPEN
OPEN
OPEN
CLOSE
CLOSE
CLOSE
Fig.14
Photo beam:
Connect the photo beam follow Figure. The photo beam output signal must be N.C. signal.
Press and hold
close
until ’─’ is indicated on the LED display. release the
close,’11’
will indicated on
the LED display. Press
open
, ’
H
’ will indicated on the LED display. Press
SET
to confirm.
Then
Connect the photo beam follow the Figure.
(
Note: When not using photo beam, please click the
above action and set to "11" status)
Photo receiver
Photo transmitter
GND
PE
24
Fig.15
9. Maintenance
Check the door once a month. The door should be carefully checked for balance. The door must be
in good working order.
The auto-reverse function should be regularly inspected, and adjusted if necessary. For service, call
an experienced serviceman.
