4
Door leaf
Drill holes based on the marked
positions.
()
Place the rubber ring between
armature plate and door leaf.
12
Close the door to test holding force.
The angle between armature plate
and magnetic lock can be adjusted
by adding or reducing washers.
Metal Surface Door
11
I
6.8mm for M8-1.25thread
lnside:Drill a hole
diameter is 8mm folding
the plastic straight pin
Template
Fold the plate to 90
°
.
5
Make a combination based on
the picture.
9
./·····-····,.,
(,,
/
J
llen Key
.....
________ _
Use Allen key to remove the
mounting plate from lock
body.
13
After all the appropriate procedures,
the holding force can be maximized.
Finally, fix the tamper screw.
A
Notice:
Thickness of Door Leaf:
2
Door Frame
Door
leaf
I
Template
Close the door first, then place
the upper side of template on
door frame, while adjust the left
side next to the door leaf.
6
Strike the pin into the armature
plate slightly (to avoid movement).
10
Jl
Fix the mounting plate on the
door frame according to the
holes drilled earlier.
Hollow Metal Door
I
16mm
I
8mm
Drill a hole
Inside: Diameter is 8mm
Outside: Diameter is16mm
3
Template
Door leaf
Mark screw positions of armature
plate and magnetic lock on door
leaf and door frame respectively.
7
Make a combination based on the
picture(add washer accordingly).
The rubber ring must be added.
11
/,,
,.-
········· ......
(
�
)
Allen Key
\
/
_/
·-......
.....
-
Use Allen key to screw the lock
body on the mounting plate.
Wooden Door
36mm
I I
12.7mm
8mm
Drill a hole
Inside: Diameter is 8mm
Outside: Diameter is 12.7mm
350LBS: 44mm 600LBS: 50mm 800LBS: 48mm 1200LBS: 46mm
A. The screw of armature plate should not be fixed too tight. Proper elasticity should be guaranteed for
the rubber ring so that the armature plate can adjust itself to the appropriate position.
B. Check the jumper's position before connecting. Figure out it represents 12VDC or 24VDC.
www.AllSecurityEquipment.com
