All-Power SP-FT22, Owner'S Manual

Page: 14 / 23

SERVICE AND ADJUSTMENT
HOW TO ADJUST
THE HEIGHT OF THE HANDLE
Use the knobs , on each side of the handle , to
adjust the height of the handle.
1. Hold the handle with one hand and loosen both
knobs until the ratchet teeth are disengaged. Do not
remove the knobs . See Figure 12.
2. Move the handle up or down to the desired position,
then align the ratchet teeth . Make sure both sides of
the handle are level.
3. Tighten the knobs
HOW TO SET THE HEIGHT OF CUT
CAUTION: Before you set the
height of cut: stop the engine.
Wait for all moving parts to stop.
Allow the engine to cool and
disconnect the spark plug wire.
The height of cut can be set from 1-1/2 inches
to 3 inches. Recommended cutting height for
the average yard is 2”.
1. Use the T-wrench , found in the parts bag,
to loosen the set screw shown in Figure 13.
2. Set the trimmer head at the desired height.
3. Tighten the set screw.
14