19.2V Cordless Drill
6
Additional Warnings
z
Secure the bit:
Make sure that the drill bit, or screwdriver bit is firmly
held by the chuck.
z
Drill bit:
Always use sharp, good-quality drill bits. The performance and
safety of the drill depends on the quality of the bits used.
z
Drilling in metal:
When drilling into metal, the materials being drilled will
become hot. To reduce overheating, use a suitable cooling lubricant. No
coolant is necessary when drilling cast iron, or brass as they should be
drilled dry.
z
Select the correct speed:
As a general rule, you should use low
speeds for large size drill bits and higher speeds for smaller drill bits.
z
Direction of rotation:
Never change the direction of rotation while the
drill is in operation.
z
Breakthrough:
Be prepared for the breakthrough of the drill bit when
drilling. The drill bit may bind on breakthrough and cause loss of control.
z
Lock directional control switch OFF:
Before removing, or installing a
battery pack, drill bit, or screwdriver bit, or making any adjustments to
the torque setting, make sure that the direction selector is in the central
locked off position.
z
Live electrical wires:
When drilling holes, or driving screws into walls,
floors etc., make sure that there are no live electrical wires in the path of
the bit.
WARNING! THE FOLLOWING EXTRA SAFETY INSTRUCTIONS REFER
TO THE CORDLESS DRILL ONLY AND MUST BE OBSERVED IN
ADDITION TO THE GENERAL PRECAUTIONS OUTLINED ABOVE.
WARNING! BEFORE REMOVING, OR INSTALLING A DRILL BIT OR
SCREWDRIVER BIT, MAKE SURE THAT THE DIRECTION SELECTOR IS
IN THE CENTRAL LOCKED OFF POSITION.
