21
Owner’s Manual
Compressor (cont’d)
BREAKING IN THE PUMP
1.Turn the switch to the OFF position.
2. Open the petcock. Turn counterclockwise (loosen).
3. Plug in the power switch to the ON position.
4. The compressor will start.
ALLOW THE COMPRESSOR TO RUN FOR 15 MINUTES, TO BREAK IN THE
INTERNAL PARTS.
CAUTION:
AFTER ABOUT 15 MINUTES. IF THE UNIT DOES NOT
OPERATE PROPERLY, SHUT DOWN IMMEDIATELY AND CONTACT
PRODUCT SERVICE CENTER 888-896-6881.
5. After about 15 minutes, turn the power switch to the OFF position.
6. Close the petcock. Turn in the clockwise direction.
7. Turn the power switch to the ON position. The compressor will start and fill the tank
to the kick-out pressure and stop.
Note:
As compressed air is used, the pressure switch will restart the
motor automatically.
Note:
During the initial break-in cycle, there will be a slight electrical
smell as the motor brushes seat.This is normal for universal motors and will last for
about 5 minutes.
OPERATING INSTRUCTIONS
Daily Startup
1. Turn the power switch to the OFF position.
2. Close the tank petcock. Turn in the clockwise direction.
3. Plug in the power cord.
4. Turn the power switch to the ON position.
