PAGE 6
2.
If necessary, add a
premium quality, 30-weight, non-detergent compressor oil
into the Oil Fill Hole until the level of oil reaches the maximum level as indicated
on the Oil Window (20B). The optimal capacity of the oil reservoir is 30 ounces.
Do not overfill
. Then thread the Breather Valve back into the Oil Fill Hole, being
careful not to strip the plastic threads.
(See Figure C, and Assy. Diagram B.)
To Turn The Air Compressor On:
1.
Check to make sure the Water Drain Valve (10A) is fully closed.
2.
Turn the Air Flow Valve (6A) to its “OFF” position.
3.
Connect the air hose (not provided) to the Air Flow Valve (6A) of the Air Com-
pressor. Then, connect the other end of the air hose to the pneumatic tool (not
provided) that is to be used.
4.
Note: Always plug the Power Cord of the Air Compressor into a 115 V~
electrical source (±10% maximum variation).
5.
Rotate the “ON/OFF” Power Switch (1A) to the horizontal position to turn the Air
Compressor
on
. (Rotate the “ON/OFF” Power Switch (1A) to the vertical position
to turn the Air Compressor
off
.)
6.
Allow sufficient time for the
Tank Pressure Gauge (4A) to indicate
80 PSI
before
using the Air Compressor.
7.
Turn the Air Flow Valve (6A) to its “ON” position to allow air to the pneumatic tool.
FIGURE C
Breather Valve (14B)
Oil Window (20B)
Front Cover (18B)
