18
Owner’s Manual
Compressor (cont’d)
BREAKING IN THE PUMP
1. Make sure air compressor is OFF.
2. Open the petcock. Turn counterclockwise (loosen).
3. Push the power switch to the ON position.
4. The compressor will start.
ALLOW THE COMPRESSOR TO RUN FOR 15 MINUTES, TO BREAK IN THE
INTERNAL PARTS.
CAUTION:
AFTER ABOUT 15 MINUTES. IF THE UNIT DOES NOT
OPERATE PROPERLY, SHUT DOWN IMMEDIATELY AND
CONTACT PRODUCT SERVICE CENTER.
5. After about 15 minutes, push the power switch to the OFF position.
6. Close the petcock. Turn in the clockwise direction.
7. Push the power switch to the ON position. The compressor will start and fill the tank
to the kick-out pressure and stop.
Note:
As compressed air is used, the pressure switch will restart the
motor
automatically.
Note:
During the initial break-in cycle, there will be a slight electrical
smell as the motor brushes seat.This is normal for universal motors and will
last for about 5 minutes.
OPERATING INSTRUCTIONS
Daily Startup
1. Close the tank petcock. Turn in the clockwise direction.
2. Plug in the power cord.
4. Connect the hose.
3. Push the power switch to the ON position.
Petcock
(located on bottom
portion of tank)
Meijer.com
