ALL POWER AMERICA PW2500, Owner'S Manual

Page: 10 / 24

10 | ALL POWER™ PW2500 PRESSURE WASHER www.allpoweramerica.com
Add Engine Oil
Do not attempt to start the pressure
washer engine without filling the
engine crank case with the proper
amount of oil. Your pressure washer
has been shipped without oil in the
crankcase. Operating the pressure
washer without oil will ruin the
engine. Use oil that is recommended
(10W-30). DO NOT OVERFILL!
CAUTION
1. Place the Pressure Washer OUTSIDE
on a flat and level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add the supplied engine oil and replace
oil dipstick.
3. Hand tighten oil dip stick and wipe off
any spilled oil.
4. Check engine oil level daily and add
as needed.
Add Fuel
1. Use clean, fresh, regular fuel with a
minimum octane rating of 85.
2. DO NOT mix oil with fuel.
3. Clean the area around the fuel cap.
4. Remove the fuel cap.
5. Slowly add fuel to the tank. DO NOT
overfill. Allow approximately 1/4 inch
of space for fuel expansion.
6. Screw on the fuel cap and wipe
away any spilled fuel.
• Use regular unleaded gasoline with a
minimum octane rating of 85.
• Do not mix oil and gasoline.
• Fill tank to approximately 1/4” below
the top of the tank to allow for fuel
expansion.
• Do not fill fuel tank indoors.
• Do not fill fuel tank when the engine
is running or hot.
• Do not overfill the fuel tank.
• Do not light cigarettes or smoke
when filling the fuel tank.
CAUTION
TECHNICAL DATA
Max. Inlet Pressure: Up to 90 PSI
Max. Pressure: 2500 PSI
Rated Flow: 2.1 GPM
Engine Model: JF168
Displacement: 208 cc
RPM: 3400 RPM
Fuel Tank: 1 gallon
Temp. of Pumped Fluids: Up To 104°F
Inlet Ports: (2) 1/2 inch BSP
Discharge Ports: M22*1.5 ɸ 14mm
Weight: 75.24 lbs.
Engine Oil: 10W-30
Fuel: Unleaded Gas
10 PRE-OPERATION/TECHNICAL DATA | OWNER’S MANUAL