Before installing your All Pond Solutions PP ensure you have read the
instructions and taken note of all safety advice. If you have any further
questions or concerns please contact the retailer before installing the
PP system.
The pump comes complete with a generous supply of 3 core cable,
however, should any additional cable be required then the use of an
approved waterproof cable connector is essential.
The power supply must be earthed and fused at 3amps.
Regularly inspect the cable for damage and deterioration
Always use a residual circuit device (RCD) for additional safety
For permanent installation to the mains supply, it is necessary to comply
with the regulations of the Local Electricity Authority.
Consult a qualified electrician if in doubt about any aspects of wiring.
Important: Disconnect the mains electricity supply before attempting
any installation/maintenance or handling of any kind.
Only run your PP fully submerged.
The PP should never be run dry as this will cause the unit to overheat
and cause permanent damage.
Do not attempt to modify this unit in any way and only use the
recommended parts for replacement.
All connections must be earthed.
Do not connect to any voltage other than that stated on the pump.
Do not place in liquids other than water
Do not use in water above 90°F or 30°C
INSTRUCTIONS
ELECTRIC
SAFETY
H(m)
0
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
8000
6800
5800
5000
3800
2000
0
LITRES PER HOUR
9000
7800
7000
5600
4800
4000
3200
2000
0
SPECIFICATION
MODEL
POWER CONSUMPTION(W)
MAX FLOW RATE (L/h)
MAX HEIGHT (m)
DISCHARGE CONECTION
VOLTAGE (V)
FILTER SURFACE
WEIGHT(kg) 10m CABLE
AC230V/50Hz
470
3.3
10000
8500
7600
6800
5400
4600
4000
3400
2800
1800
10000PP
9000PP
70
8000
3.2
8000PP
95
9000
3.6
AC230V/50Hz
470
3.3
155
10000
5
AC230V/50Hz
470
3.5
POND AND AQUARIUM
POND AND AQUARIUM
WATER PUMP
WATER PUMP
INSTRUCTION MANUAL
INSTRUCTION MANUAL
8000PP
8000PP 9000PP
9000PP 10000PP
10000PP
50%
MORE ENERGY
EFFICIENT
50%
EFFICIENT
MORE ENERGY
/
/
//
